MakerBot Replicator Z18 Manual do Utilizador descarregar pdf (Página 8)

WELCOME.8

SAFETY AND COMPLIANCE

Safety alert symbols precede each safety message in this manual. These symbols indicate

potential safety hazards that could harm you or others or cause product or property damage.

Warning: The MakerBot Replicator Z18 generates high temperatures. Always allow

the MakerBot Replicator Z18 to cool down before you reach inside.

Warning: The MakerBot Replicator Z18 includes moving parts that can cause injury.

Never reach inside the MakerBot Replicator Z18 while it is in operation.

Warning: There is a risk of shock. The MakerBot Replicator Z18 is not user serviceable.

Caution: Avoid leaving the MakerBot Replicator Z18 unattended during operation.

If you must leave the MakerBot Replicator Z18 unattended during a print, exercise

caution and follow these guidelines:

• • Verify that the MakerBot Replicator Z18 has started the print and is

operating normally.

• • Ensure that ﬁlament is wound tightly on the spool, free of tangles

• and feeding properly.

• • Monitor your print periodically.

• • If possible, monitor your print via the on-board camera.

•

Caution: Two people are required to li the MakerBot Replicator Z18. Do not li

alone. To prevent injury, li with your legs, not your back.

Caution: Do not print using materials that have not been approved by MakerBot for

use with the MakerBot Replicator Z18. Refer to the Speciﬁcations section on page 61

for more information.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 66 67

Sem comentários

MakerBot Replicator Z18 Manual do Utilizador Página 8