MakerBot Replicator Z18 Manual do Utilizador descarregar pdf (Página 58)

TROUBLESHOOTING58

LEVELING THE BUILD PLATE

4. Follow the directions on the control panel.

The Makerbot Replicator Z18 will move the

Smart Extruder to dierent positions on

the build plate. At each point it will prompt

you to adjust one of the leveling knobs and

prompt you again when the plate is in the

correct position.

Caution: Only turn the leveling knobs

as directed by the instructions on the

control panel.

5. When the leveling process is ﬁnished,

tighten down the four locking bolts to secure

the build plate.

6. When the build plate is locked into place,

the MakerBot Replicator Z18 will go through

a short calibration sequence. Wait until the

calibration sequence is complete before

initiating any other action on your MakerBot

Replicator Z18.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 66 67

Comentários a estes Manuais

Sem comentários