MakerBot Replicator Z18 Manual do Utilizador descarregar pdf (Página 40)

MAKERBOT DESKTOP40

USING THE CAMERA

A feed of images from the onboard camera is always available when you’re connected to your

MakerBot Replicator Z18 via Wi-Fi or Ethernet. To view the feed, click the menu icon at the

right side of the status bar to open the monitor panel. As long as you are connected to your

MakerBot Replicator Z18 via a network, the camera image will refresh every few seconds.

When you connect your new MakerBot Replicator Z18 to MakerBot Desktop for the ﬁrst

time, the camera image may be blurry. You will need to focus it manually to get the best

image possible.

To focus the camera:

1. Connect the MakerBot Replicator Z18 to

MakerBot Desktop via Wi-Fi or Ethernet and

click the status bar to open the monitor panel.

2. Locate the camera. It is mounted inside

the front right corner of the MakerBot

Replicator Z18.

3. Grasp the plastic ring around the lens

and twist it slightly. Avoid touching the camera lens itself.

4. Check the camera feed and wait for the image to refresh. If the image is clearer than it

was before, continue twisting the lens in the same direction. If the image is less clear, start

twisting the lens in the opposite direction.

5. Twist in small increments, and check the camera feed frequently. When the image is

clear and twisting in either direction makes it more blurry, stop making adjustments. You

have successfully focused the onboard camera.

PRINTING FROM MAKERBOT DESKTOP

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 66 67

Sem comentários

MakerBot Replicator Z18 Manual do Utilizador Página 40