MakerBot Replicator 2 Manual do Utilizador descarregar pdf (Página 52)

52 E TROUBLESHOOTING, DIAGNOSTICS, AND MAINTENANCE

MAINTENANCE CONTINUED

Adjusting the Plunger | Continued

2. Aer you’ve removed the screws, move

the active cooling fan to the side. Push the

wires out of the way so you have a clear

view of the black plastic drive block.

3. Locate the small round hole in the drive

block. Insert the 2mm hex wrench included

with your Makerbot Replicator 2 into the

hole until you feel it seat itself in the set

screw inside.

4. Use the hex wrench to turn the set screw

very slightly clockwise to put more pressure

on the ﬁlament. Turn it very slightly counter-

clockwise to put less pressure on the

ﬁlament. Turn the screw no more than one

eighth of a turn.

5. Remove the hex wrench.

6. Reseat the active cooling fan, being

careful of the fan wires.

7. Use the Phillips head screwdriver

to reattach the active cooling fan to

the extruder.

Updating Your Firmware

Keeping your ﬁrmware up to date will ensure that your MakerBot Replicator 2 always

operates at its best. When MakerWare tells you that there’s a new ﬁrmware release, click

the MakerBots menu and select Upload Firmware.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 58 59 60

Sem comentários

MakerBot Replicator 2 Manual do Utilizador Página 52