MakerBot Replicator 2 Manual do Utilizador descarregar pdf (Página 44)

44 E TROUBLESHOOTING, DIAGNOSTICS, AND MAINTENANCE

DIAGNOSTICS LCD PANEL | TOP-LEVEL MENU

BUILD FROM SD Displays the list of models on the SD card. Select one to start a build

PREHEAT Allows you to preheat the extruder.

UTILITIES Tools that allow you to conﬁgure and maintain your

MakerBot Replicator 2.

INFO AND SETTINGS Optional settings and information about the MakerBot Replicator 2.

LCD: The Top-Level Menus

PROBLEM SOLUTION

TROUBLESHOOTING CONTINUED

Extrusion stops during

a build

Your build plate might be so close to the extruder that it is

preventing plastic from coming out of the nozzle. Tighten

each knob on the bottom of the build plate by a quarter

turn to move the platform farther from the extruder nozzle.

Extrusion could also stop if there is too much or too little

tension on the plunger inside the extruder. If you hear a

faint clicking noise coming from your extruder, the plunger

is exerting too much pressure. If you can stop the ﬁlament

from feeding by squeezing it between your ﬁngers, the

plunger is exerting too little pressure. Use the plunger

adjustment section on page 51 of this manual to set the

tension correctly.

NOTE: For more detailed troubleshooting information, see the MakerBot Replicator 2 Troubleshooting

page makerbot.com/support/replicator2/troubleshooting. For video walkthroughs of troubleshooting

issues, see the MakerBot Replicator 2 video collection makerbot.com/support/replicator2/videos.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 59 60

Sem comentários

MakerBot Replicator 2 Manual do Utilizador Página 44