MakerBot Digitizer Manual do Utilizador descarregar pdf (Página 8)

SAFETY AND COMPLIANCE

The MakerBot Digitizer Desktop 3D Scanner uses two (2) Class 1 lasers when it is scanning.

The Digitizer is reported certiﬁed as a Class 1 laser product under the requirements of 21 CFR

(J) 1040.10 and IEC 60825-1 as per Laser Notice 50. Class 1 lasers are safe under all conditions

of normal use. This means the maximum permissible exposure (MPE) is not exceeded when

viewing a laser with the naked eye or with the aid of typical magnifying optics.

Wavelength

Total Laser Power (per laser)

Number of Lasers

Laser Power for Classiﬁcation

Mode of Operation

Beam Diameter

Divergence

650nm, nominal

<3.5mW

<300μ W

CW (continuous wave)

<5mm

1 Radian x <5mRadian

Warning: The laser is never to be operated if the unit is defective or the cover, seal or

output lens is damaged.

Caution: Use of controls or adjustments or performance of procedures other than those

speciﬁed herein may result in hazardous radiation exposure.

Laser Safety

Laser Parameters

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 73 74

Sem comentários

MakerBot Digitizer Manual do Utilizador Página 8