MakerBot Digitizer Manual do Utilizador descarregar pdf (Página 7)

WELCOME, LET’S GET STARTED 7

SAFETY AND COMPLIANCE

WELCOME, LET’S GET STARTED

This safety alert symbol precedes each safety message in this manual. This symbol

indicates a potential safety hazard that could harm you or others or cause product or

property damage.

Warning: If the MakerBot Digitizer gets wet, immediately disconnect it from power and

allow it to dry completely before attempting to use it again.

Caution: Handle the MakerBot Digitizer with care; it includes sensitive electronic and

optical components that may be damaged if it is bumped or dropped.

Caution: Avoid excessive humidity or temperatures. When the MakerBot Digitizer is in

use, avoid temperatures above 32° C or below 0° C. Do not store the MakerBot Digitizer

in areas where temperatures exceed 32° C or fall below 0° C.

Important safety information is contained in this manual. Please read the following

messages thoroughly before using the MakerBot Digitizer™ Desktop 3D Scanner.

To use the MakerBot Digitizer safely, adhere to the following guidelines:

• Do not touch the camera ﬁlter or camera lens; oil or smudges may decrease the

MakerBot Digitizer’s performance.

• Do not touch the laser housing while the MakerBot Digitizer is powered on.

• Do not operate the MakerBot Digitizer if any part of the machine is cracked or

otherwise damaged.

• Only use the provided power supply with the MakerBot Digitizer.

• Do not use power or USB cables if damaged.

• Do not force USB or Power connector into place.

• The socket-outlet must be installed near the equipment and must be easily accessible.

1 2 3 4 5 6 7 8 9 10 11 12 ... 73 74

Sem comentários

MakerBot Digitizer Manual do Utilizador Página 7