MakerBot Replicator 2x Manual do Utilizador descarregar pdf (Página 71)

TROUBLESHOOTING

FILAMENT STUCK

Filament can swell inside the extruder and get stuck. If you cannot unload filament

from one of the extruders, do the following:

1. On the LCD panel, navigate to Utilities > Change Filament > Unload. This option

heats the extruders.

2. Set the extruder arm to the open position.

3. Push about half an inch of ﬁlament through the extruder to clear the blockage. Try

pulling the ﬁlament out of the extruder again.

If you are unable to unload filament because it has broken off inside the extruder, you

might not be able to reach inside the extruder to clear the blockage. In that case, see

the section Disassembling an Extruder.

PRINTING ISSUES CONTINUED

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 91 92

Sem comentários

MakerBot Replicator 2x Manual do Utilizador Página 71