MakerBot Replicator 2x Manual do Utilizador descarregar pdf (Página 11)

Page 10

Rev.2

E. Lower Build Plate

After the build plate has been leveled, you need to lower the build plate.

To lower the build plate >> Utilities > Jog Mode > [Press the RIGHT arrow to

get to “z”] > [Press the DOWN arrow to lower the build plate].

YOU MUST LOWER THE BUILD PLATE BEFORE YOU LOAD FILAMENT!

F. Load Filament

To load filament, select a filament color, load it onto the back of the printer,

cut the filament past any bends and feed it through the tube heading to the

right extruder.

To begin the loading process, select: Utilities > Change Filament > Load Right.

After the extruder heats up, you will be prompted to feed the filament into the

extruder. KEEP THE FILAMENT AWAY FROM THE COOLING FAN!

When feeding the filament into the extruder, place it down the feed hole and

pull back lightly to ensure the extruder has grabbed the filament.

Connect the feed tube to the extruder after the filament begins to load and

watch for filament to begin extruding below the extruder.

Once plastic starts to flow, wait until the color of the extruded plastic matches

the color of your selected filament, then wait an additional 5 seconds to make

sure the system is properly purged.

Figure 6 - Loading Filament

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Sem comentários

MakerBot Replicator 2x Manual do Utilizador Página 11